Expobar G-10 Service Manual download pdf (Page 28)

G-10

SERVICE PROGRAMMING

Accessing service programming

STAND-BY (OFF)

Next menu

Stand-by + Press >14 s → Service prog.

+ - OK

Language selection

Accessing these settings menus is only possible via the left-hand button panel (when

the machine is viewed from the front).

To access the settings menus:

Turn the machine OFF (stand-by) by pressing and holding down the Continuous

Dispensing button

whilst the machine is ON then pressing the 2 Short

Espressos button

(see fig. 11).

Hold down the Continuous Dispensing button for 15 seconds (until the

display shows the "Language" option, see fig. 12).

OFF hh:mm

Fig. 11

When "Language" is displayed, select the desired language.

To change language:

Press the 1 Short Espresso button (+) to cycle forward through the languages

and the 1 Long Espresso button

(-) to cycle backward through them.

Languages available: Spanish, English, French, Italian, German and Portuguese.

To accept the language selected and access the next menu, press the Continuous

Dispensing button

Language

Fig. 12

Reset parameters to factory default

Data reset

completed

Fig. 10

To reset the control panel settings to the factory default:

Switch off the machine at the power switch.

Press and hold down the '1 Short Espresso' , 2 Short Espressos and

Continuous Dispensing buttons

then turn on the machine. Hold down the

buttons until the message shown in fig. 10 is displayed.

Turn the machine off and then on again. The machine will now be in stand-by mode.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

No comments

Expobar G-10 Service Manual Page 28